Search

Module A-111-2 is the successor of the obsolete High End VCO I A-111-1.Here are the most important features of the planned module:triangle coremin. 15 octaves pitch range (typ. 0.5Hz - 20kHz)perfect 1V/octave tracking over min. 10 octaves (typ. 20Hz - 20kHz)exponential frequency controls and in..

Module A-111-3 is an extremely space-saving precision VCO/LFO with a 4HP panel only. Essentially it's the same basic circuit as the A-111-2 but with reduced features:triangle corefully analog designmin. 15 octaves pitch range in each mode (VCO/LFO):VCO mode: typ. 0.5 Hz - 20 kHz ..

Module A-112 is the combination of a voltage controlled 8 Bit Sampler and a wavetable oscillator. On top of it the module is able to generate some special effects. A-112 was designed as an additional sound source with the typical sounds of the early 8 bit samplers and is not comparable with the mode..

Module A-114 contains two separate ring modulators. A ring modulator outputs the product (Multiplication X • Y) of the signals at inputs X and Y. It's similar to a VCA, but whereas a VCA only responds to positive voltages at the inputs (2-quadrant multiplication), the ring modulator responds to both..

Module A-118 is (as you might have guessed) a noise and random voltage generator. It produces three types of signal: white noise, colored noise, and random voltage. The noise signal is generated 100% analog by amplification of the noise of a transistor. White and colored noise can be used as audio s..

Module A-119 (External Input / Envelope Follower) is designed to allow external audio signals to be integrated into the System A-100. It comprises a pre-amp, envelope follower, and comparator.The pre-amp has two inputs: an unbalanced input for line level signals, with a gain factor of from 0 to 20, ..

Module A-120 is a voltage controlled low-pass filter, which filters out the higher parts of the sound spectrum, and lets lower frequencies pass through. The Cut-Off Frequency determines the point at which filtering takes effect. You can control this manually, or by voltage control (filter modulation..

Module A-124 is a special 12dB multimode filter using the "strange" filter circuit of the "EDP Wasp" (an analog synthesizer with black/yellow case built end of the seventies, manufactured by the UK company "Electronic Dream Plant" with Chris Huggett und Adrian Wagner). This design "abuses"..

Module A-138 is a four channel mixer, which can be used with either control voltages or audio signals. Each of the four inputs has an attenuator, and there's a master attenuator, so that the mixer can be used at the end of the audio chain - ie. it can be used to interface directly with an external m..

Module A-138 is a four channel mixer, which can be used with either control voltages or audio signals. Each of the four inputs has an attenuator, and there's a master attenuator, so that the mixer can be used at the end of the audio chain - ie. it can be used to interface directly with an external m..

DOEPFER A-100 B2, BLINDPL./BLIND PANEL 2TE/10MM..

DOEPFER A-100 B4, BLINDPL./BLIND PANEL 4TE/20MM..