Module A-190-8 is a Midi/USB to Sync interface. The main application of the module is the control of clocked A-100 modules like sequencers (A-155), sequencer controllers (A-154), trigger divider (A-160 or A-163), trigger sequencer (A-161) and similar units. It may be used also to res..
Module A-192-2 contains two independent CV/Gate-to-Midi/USB interfaces. For each of the two sub-units these inputs are available: Gate Input (min. +5V)CVN Input (defines the Midi note number), 1V/octave standard, range 0...+10V (i.e. 10 octaves)CVV Input (defines the velocity value assigned to ..
Module A-196 contains a so-called phase locked loop (PLL). The basic PLL system is shown in the sketch at the bottom of this page. A PLL consists of three parts: voltage-controlled oscillator (VCO), phase comparator (PC), and low-pass filter (LPF). All parts are normally connected to form a closed-l..
Module A-198 is a Trautonium Manual resp. Ribbon Controller. The controlling element of the A-198 is a linear position sensor (length about 50 cm) that has available a pressure sensor too. (the color of the A-198 manual will be changed to black, so that for R2M and A-198 the same..
Module A-199 is a spring reverb module. The reverb effect is electronically simulated by means of 3 spiral springs. Spring reverb systems have a very characteristic sound that is based on the (insufficient) mechanical properties of the springs like signal delays, audio resonances, limited freq..
Module A-199 is a spring reverb module. The reverb effect is electronically simulated by means of 3 spiral springs. Spring reverb systems have a very characteristic sound that is based on the (insufficient) mechanical properties of the springs like signal delays, audio resonances, limited freq..
DOEPFER A-100 BUS BOARD 4, INCL. 4 WIRES WITH FLAT CONNECTORS ON BOTH ENDS, LENGTH ABOUT 30CM, COMPATIBLE WITH ROLAND AIRA SERIES (REQUIRES PSU3 POWER SUPPLY)..